Raven B463 El Manual Del Propietario página 8

a
SSembly
CAUTION
Do not remove discharge guard from mower. Raise and
hold guard when attaching lower chute and allow it to
rest on chute while in operation.
Unit Assembly
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting cover assembly
to tractor.
1. Locate Adapter Frame and remove the (2) small "L"
Brackets and (2) Snap Pins from it.
Adapter Frame
2 On the rear of your MPV, located the (4) bolts (2 per
side) directly below the tailgate. Use a 10mm and
12mm wrench to loosen and remove all (4).
3. Mount the "L" Brackets as below. HAND TIGHTEN
ONLY.
Left Bracket
8
D142100 R1 Bagger Manual_Final - English.indd 8
"L" Brackets
Snap Pins
Right Bracket
4. Locate the Adapter Frame and slide it between the tabs
of the "L" Brackets oriented as shown. Slide the Snap
Pins through the brackets and the frame and secure.
LEFT
Tab
Snap Pin
Rear View - Fully Assembled
5. Locate the Lid/Frame Assembly place it on a smooth,
flat surface oriented as shown.
6. Locate the "U" Subframe and slide it onto the short
stubs located at the bottom of the main frame. Ensure
the locating pin at the bottom of the "U" Subframe is
oriented as shown. Locate the (2) long hex bolts and
(2) hex nuts and install through holes of "U" Subframe
HAND TIGHT ONLY.
RAVEN B463 Bagger System
RIGHT
Tab
Snap Pin
4/9/2015 8:50:49 AM