Troubleshooting - DeWalt DXV06G Manual De Instrucciones

ENGLISH
CARE AND MAINTENANCE
FILTER REPLACEMENT
WARNING:
To reduce the risk of injury from accidental
starting, shut off vacuum and disconnect the
power plug from the wall outlet before changing
or cleaning the lter. The lter should be cleaned
often to maintain peak vac performance.
IMPORTANT:
To avoid damage to the impeller and motor,
always reinstall the Clean Connect™ lter before
using the vac for dry pickups and wet pickups.
IMPORTANT:
After cleaning, check the lter for tears or small
holes. Do not use a lter with holes or tears
in it. Even a small hole can cause a lot of
dust to come out of the vac.
Replace it immediately.
NOTICE:
Before installing the lter on the vac, clean the
area of the lid so that the lter will seal against
the lid and stop small particles from bypassing
the lter bag. If the lter is clean and not
damaged, replace it on the lter cage.
If it cannot be reused, place a new lter over
the lter cage.
NOTICE:
Clean the lter in an open area. Cleaning should
be done outdoors and not in living quarters.
CLEANING
To keep the wet/ dry vac looking its best, clean
the outside with a cloth dampened with warm
water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and
mild soap.
3. Wipe out with dry cloth.
STORAGE:
Store the power cord wrapping it
around the bottom accessory
box/cord wrap . The hose may
be wrapped around the wall
bracket and the accessories
stored in the tool box so they can
be readily available. Never allow
liquids to sit in the tank for any
extended period of time. The
vacuum should be stored indoors.

TROUBLESHOOTING

Minor problems often can be xed without calling
customer service.
PROBLEM
Check power cord, plugs and outlet.
Motor does not run
Ensure the on/ off switch is in the
ON position ( I )
Remove blockages in the suction
nozzle, suction tube, suction hose
or lters.
Replace the paper or eece dust bag.
Suction capacity
decreases
Clean or replace the lters.
Empty the dust tank, refer to
the tank
instructions.
Thermal overload has been tripped:
1. Turn the vacuum off and
Vacuum stops
2. Empty the canister, if needed.
running
3. Allow the unit to cool (around 3-5
minutes).
4. Plug the power cord into an
Check for proper installation of the
lters.
Dust comes out
Ensure lters are not damaged;
while vacuuming
replace if necessary.
Ensure lter seals are in place and
are secure.
8
SOLUTION
Operating
under
disconnect vacuum cleaner from
power source.
appropriate outlet and turn on/off
switch to the ON position ( I ) to
test. If vacuum will not restart
call 1-888-899-0146
Empty