Setting The Clock; To Set The Clock; Stop/Clear - Viking RVMHC330 Manual De Uso Y Cuidado

Setting the Clock

Before operating your new Microwave Oven make sure you read and understand this Use and Care Guide completely.
The following steps MUST be taken before any functions can be used. Before you use the Microwave Oven:
Plug in the microwave oven. Close the door. The microwave oven display will show
1.
2. Touch the Stop/Clear pad.
3. Set clock.

To Set The Clock

1. Touch Clock pad.
2. Enter the correct time of day by touching the numbers in sequence. Touch Clock pad again.
This is a 12 hour clock. If you attempt to enter an incorrect clock time,
Clear pad and re-enter the time.
• If the electrical power supply to your microwave oven should be interrupted, the display will intermittently show
after the power is reinstated. If this occurs during cooking, the program will be erased. The time of day
WELCOME
will also be erased. Simply touch Stop/Clear pad and reset the clock for the correct time of day.
NOTE:
Your oven can be programmed with the door open except for Start/Touch On, Add-A-Minute, Reheat and Popcorn.

Stop/Clear

Touch the Stop/Clear pad to:
• Erase if you make a mistake during programming.
• Cancel timer.
• Stop the Microwave Oven temporarily during timed cooking.
• Return the time of day to the display.
• Cancel a program during cooking, touch twice.
E
:
will appear.
14
WELCOME
ERROR will appear in the display. Touch the Stop/
.