Cleaning and Maintenance
Grease Filters
Filters should be cleaned at least once a month. Never operate the fan or oven without
the filters in place.
1. Pull down slightly on the tab toward the front of the oven and remove the filter.
Repeat for the other filter.
2. Soak the filters in a sink or dish pan filled with hot water and detergent. DO NOT
use ammonia or other alkali; they will react with the filter material and darken it.
3. Agitate and scrub with a brush to remove embedded dirt.
4. Rinse thoroughly and shake dry.
5. Replace by fitting the filter back into the opening.
Fan
The fan will automatically start when heat rises from the cooking surface and when convection, high mix, low mix or the
broil settings are used. This protects the microwave oven from excessive temperature rise. The fan will stay on until the
temperature decreases. It cannot be turned off manually during this time.
For other uses, select either high or low speed.
PRECAUTIONS FOR PROPER USE:
1. DO NOT leave cooking surface unattended while using high temperatures. Automatic fan may start and provide exces-
sive air to the surface units. This may cause spattering or boilover.
2. Avoid burning food.
3. Keep grease filters clean.
Light
1. To replace light bulbs, first disconnect power to the microwave oven at the
circuit breaker panel or by unplugging.
2. To release cover remove the screw on the light cover. (See illustration.)
3. Replace bulbs with only 20 watt and 40 watt bulbs. These are available at
most hardware stores or lighting centers. The unit will be shipped with one
20 watt bulb and one 40 watt bulb. DO NOT USE A BULB LARGER THAN 40
WATTS.
4. Close light cover and secure with screw removed in step 2.
CAUTION
Light cover may become very hot.
Do not touch glass when light is on.
Do not use light for long time use
such as a night light.
33
Filter
Ring
Light
bulbs
Light cover
Screw
E