GE SK07 Guia De Instalacion

!
"
Installation Guide
! 1
Electrical connection:
connection (automatic change of tone):
3
Automatic tone change; Siren.
D
ESCRIPTION
The SK07 multitone siren is designed for indoor use. It combines a
high sound level with a very low power consumption, configurable
tone and reduced size. A total of 8 acoustic sequences are
available.
This device meets all requirements stated by European Standard
EN 54-3.
C
ONFIGURATION
The siren should be configured prior to installation. Configurable
options include:
Acoustic power selection
Acoustic sequence selection
The DIP switches located at the rear of the siren are used for
configuration.
Acoustic power selection
Use DIP switch 4 to select acoustic power: set to ON for maximum
power and to OFF for minimum consumption.
© (2004) GE Interlogix B.V.. All rights reserved.
Version 2-1 / August 2004
55300702
2 "
Fire panel; Siren. Electrical
1
Fire panel;
SK07 Low Consumption Multitone Siren
Acoustic sequence selection
Use DIP switches 1 to 3 to configure the sounder tone (see Table
1: Acoustic sequence configuration for available options). The
preselected tone will last while the sounder is powered on or a
signal of change of tone is activated (see Automatic Change of
2
Tone).
Table 1: Acoustic sequence configuration
DIP Switch
1 2 3
OFF OFF OFF Continous sound at 3 KHz
OFF OFF ON
OFF ON OFF Fast sweep from 900 Hz up to 1800 Hz
OFF ON ON
ON OFF OFF
ON OFF ON
ON ON OFF
ON ON ON
Installation Guide
Acoustic Sequence
Slow sweep from 500 Hz up to 1 KHz
Slow sweep from 900 Hz up to 1800 Hz
Double tone of 800 Hz and 1 KHz with fast
transition
Double tone of 800 Hz and 1 KHz with slow
transition
Double tone of 440 Hz and 554 Hz with fast
transition
Continuous sound at 770 Hz