Overload Protection - Flex MXE 1000 Instrucciones De Funcionamiento Originales

MXE 1000/MXE 1002/MXE 1200/MXE 1202
Regulating the speed
(MXE 1002/1200/1202)
 To adjust the maximum working speed,
set the speed preselector switch to the
desired stage.
Speed
Stage
1
2
3
Switching the mixer on and off
The mixers are equipped with an
accelerator switch. It allows the speed to be
gradually increased up to working speed.
Switching on without locking:
 Press and hold down the switch (1.).
 To switch off, release the switch (2.).
Switching on with locking:
CAUTION!
Following a power failure, the switched-on
power tool will start running again. Always
switch the tool off!
 Press and hold down the switch (1.).
 To lock into position, hold down the
locking button (2.) and release the switch.
I II
210 320
325 490
530 780
 To switch off, briefly press and then
release the switch (3.).
Operating instructions
 After it has been switched off, the mixer
runs on for a short time.
 If the rotating mixer paddle strikes
a surface, it could cause a jolt.
 Only switch on the tool after the mixer
paddle has been immersed in the
product to be mixed. When doing this,
slowly press the switch and wait until the
tool has reached maximum speed.
 When taking a break from work, place the
tool down on the rests.

Overload protection

In the event of a short and extreme
overload, the overload protection device
prevents damage to the motor by switching
the tool off automatically.
For further information on the
manufacturer's products go to
www.flex-tools.com.
15