Publicidad
Idiomas disponibles
Idiomas disponibles
RESTRICTIONS :
Toute garantie implicite sera limitée dans sa durée à la garantie expresse précisée ci-dessus.
Dans tous les cas, la responsabilité liée à la garantie de SICCOM SAS est strictement limitée au
remplacement ou à la réparation du produit fourni augmenté du coût de son transport au lieu de
livraison d'origine.
N
i le veNdeur Ni le fabricaNt Ne porte de respoNsabiblité eN cas de blessure ou de dommages direc
temeNt eN rapport avec le produit ou coNsecutivemeNt à soN utlisatioN
NoN restrictive les pertes de gaiNs fiNaNciers
aux persoNNes directemeNt eN rapport avec le produit ou coNsecutivemeNt à soN utlisatioN
'
que tout prejudice decoulaNt de l
utilisatioN ou de l
agreaNt cette situatioN comme etaNt saNs recours et saNs compeNsatioN
LA GARANTIE SERA INVALIDÉE DANS LES CAS SUIVANTS :
Couvercle du bloc pompe ouvert
Produit connecté à une mauvaise tension secteur
Pompe utilisée avec tout autre liquide que de l'eau de condensats issue d'un chaudière.
Mauvaise utilisation de la pompe par le Client
Alarme non connectée
Avant toute utilisation, l'utilisateur déterminera la compatibilité du produit avec l'utilisation qu'il
souhaite en faire. Il supportera tout risque et implication légale en relation avec son utilisation et
son installation.
SICCOM SAS se réserve le droit de modifier tout ou partie du produit sans en informer au
préalable ses clients.
DESCRIPTION
Due to its small size the mini FLOWATCH 2 DUO is easy to use in all condensing boilers of
60 kW.
The mini FLOWATCH
2 DUO comes in 2 modules:
®
pump module (pump + control circuits)
detection module
(3 levels float: Pump shut-down, Pump start-up and alarm.)
General characteristics
Max flow:
Condensate acidity
Temperature of liquid
Max discharge:
Maximum suction:
Rating :
Voltage:
Pump power:
Ingress protection:
Thermal protection:
Noise level :
*
= The pump is able to run 100% on the time if necessary.
Operating temperature:
INSTALLATION
2.A PUMP MODULE
The power supply must come from a different network than the
Disconnect the power supply before installation.
The alarm.
There is a change-over contact with a switching power of 5 A max (resistive load 250VAC),
and a switching power of minimum 10mA under 5VDC. Use the alarm to signal (light or buzzer
signal) of any overflow risk (NO contact), and to stop further condensate water being produced
(NC contact). Use the supplied 3-core cable as follows:
Black=normally closed = NC White= common = C Purple = normally open = NO
Installation of the pump module.
The pump module may be installed in the boiler using a damper bracket and a pump module
(
-
y
compris mais de façoN
,
'
,
pertes de chiffres d
affaires
dommages aux bieNs ou
'
'
impossibilite d
utiliser le produit
.
UK
19 Litres / hour.
pH ≥ 2,5
35 °C max
10 meters – 32 ft.
0.5 meters – 1.64 ft.
100 % duty cycle*
220-240 V 50/60 Hz
19 W
IP64
yes, with auto-restart
19.7 dBA* at 1 meter distance
5°C to 45°C
boiler.
mount. A space must be left around the pump module for it to cool in the event of prolonged
operation. The pump module should not be covered (no insulation, no expanding foam, etc.).
The discharge tube (not supplied) must be 6 x 9 mm in diameter to be fixed to the 4 x 6.4 mm
reducer (already installed). Use a hose clamp (not supplied) to securely fasten the discharge
hose to the pump. Make sure to observe the flow direction indicated by the arrow on the pump
-
module.
)
2.B DETECTION MODULE.
aiNsi
,
'
l
utilisateur
The detection module is supplied with VERY LOW VOLTAGE from the pump module. It is
imperative to use the supplied 4-core cable. A flexible elbow with a diameter of 15 x 22 mm and
a length of 60 mm (supplied) allows connection detection module of the fluted evacuation hose
with the condensate water from the boiler. Suction is via the 0.25-meter flexible silicone hose
having an interior diameter of 4 mm (supplied). Use the two hose clamps (provided) to securely
fasten the flexible hose to the detection and pump modules. Connect the vent hose (supplied),
which has an inner diameter of 4mm and a length of 150 mm.
Installation of the detection module.
For the mini FLOWATCH ® 2, the detection module must be installed and fastened in a horizon-
tal position with the fixing rail (supplied) if possible. Choose the most appropriate outlet for the
application and close with the black cap the outlet which is not used.
Before plugging the connectors, check they are clean, dry and not live
Plug all connectors, paying attention to foolproofing aids and perfect fit
The outlet discharge tube of the pump module must always be higher than the detection
module. In other case, it is necessary to connect the outlet discharge tube to another tube of a
higher diameter in order to prevent siphoning. Detailed information is available from your near-
est wholesaler.
OPERATION
Before finishing the installation, it is recommended testing the correct operation of the conden-
sate removal pump.
Never try to run the pump "dry" without water (pump destructive).
Position the detection unit in order to collect the condensate from the air conditioner.
Operate the boiler to obtain condensates.
Check the pump starts, pumps water, then stops.
Test the alarm by disconnecting the connector from the detection module until the float operates
the alarm; reconnect the connector of the detection module and verify the electrical activation of
the alarm upon contact.
3.A MAINTENANCE.
Any maintenance on the condensate pump MUST BE DONE WITH THE POWER SUPPLIED
SWITCHED OFF.
At the beginning of the season, or regularly if the air conditioner is used all year long:
Remove the cap of the detection unit, the filter and the magnet. Clean inside the detection unit
and the float with water containing 5% bleach. Rinse thoroughly after use of a cleaning prod-
uct. Check the good position of the rubber seal in the housing of the cover.
Then replace the float with the magnet facing up, and the filter. Replace the cap and do a full
operational test.
3.B SAFETY
All the product is IP64 (NF EN 60529 standards)
SICCOM strongly recommend connecting the high-level alarm cable to a light or audible alarm.
A thermal cut-out set with AUTO-RESET
Connect the earth wire of the pump
WARRANTY
Your pump is guaranteed to be in perfect working order at delivery. Pumps produced by SIC-
COM SAS are guaranteed for two years (24 months) from the SICCOM SAS billing date against
all operating faults. In the case of detection of a fault, customers not located in France must
return the pump postage paid to the nearest SICCOM distributor. All products returned will be
subject to a complete analysis of origin and operation in relation to its traceability code and the
technical performances ascertained. If it is determined that the fault is unrelated to incorrect use
of the pump and that the installation instructions have been complied with, the product will be
repaired or replaced.
RESTRICTIONS:
Any implicit guarantee will be limited to the duration of the express guarantee specified above.
In all cases, the responsibility related to the SICCOM SAS warranty is limited to the replacement
or repair of the product supplied plus the cost of its transport to the original delivery location.
N
either the veNdor Nor the maNufacturer is respoNsible for iNjuries or damages directly related
to the product or subsequeNt to its use
,
turNover
damage to goods or persoNs directly related to the product or resultiNg from its use
or aNy prejudice arisiNg from the use of or iNability to use the product
situatioN is without recourse or compeNsatioN
THE WARRANTY WILL BE INVALIDATED IN THE FOLLOWING CASES:
Pump motor cover opened
Product connected to an incorrect supply voltage
Pump used with all liquid other than condensates from boilers.
Incorrect use of the pump by the customer
Alarm not connected
Before using the product, the user must determine whether it is compatible with his or her
intended use of the product. They will be responsible for all risks and legal implications resulting
from its use or installation.
SICCOM SAS reserves the right to modify the product completely or
informing its customers about it
AVVERTENZE
Di scarso ingombro, il mini FLOWATCH DUO si colloca facilmente in tutti i caldaia (la cui poten-
za frigorifera non supera i 60 KW.
Il mini FLOWATCH
®
blocco pompa (pompa + scheda di gestione)
blocco di rivelazione (3 livelli con galleggiante: Marcia pompa, arresto pompa e allarme)
Caratteristiche generali
Portata max. :
Acidità di condensa:
Temperatura del liquido:
Mandata max. :
Fattore di funzionamento :
Aspirazione max :
Alimentazione blocco pompa :
(
iNcludiNg but Not limited to loss of profit
.
IT
2 DUO è composto da due elementi:
19 l/ora
Ph' ≥ 2,5
35°C max.
10 metri
100 %*
0,5 metri
220-240 V 50/60 Hz
,
loss of
)
. t
he user agrees that this
partially without first
2
Publicidad
