Technical Data; Power Requirements - Truper LAVA-2000T Manual Del Usuario

Technical data

Description
Maximum Pressure
Maximum Inlet Pressure
Maximum Inlet Temperature
Maximum Water Flow
Power Supply Cable
High-Pressure hose
Conductors
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING

Power Requirements

WARNING In the event of faults or severe malfunction, the ground connection
delivers a trajectory with minimum resistance for power supply reducing the risk of
electric shock. This tool is built with a power cord with a connector and plug connected
to ground. The plug shall be connected into a power source installed and grounded
according to all the local codes.
WARNING
When using an extension cord, verify the gauge is enough for the
power that your product needs. A lower gauge cord will cause voltage drop in the line, resulting in power loss and
overheating. The following table shows the right size to use depending on cord's length and the ampere capability
shown in the tool's nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
From 0 and up to 10 A
From 10 and up to 13 A
From 13 and up to 15 A
From 15 and up to 20 A
WARNING When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are specially designed for
operating outdoors and reduce the risk of electric shock.
Code
Voltage
127 V
Current
Duty Cycle
50 min work per 20 min rest. Maximum 6 hours daily
Insulation
Number of
Conductors
3 (one grounded)
LAVA-2000T
18297
Electric Pressure Washer
2 000 PSI
87 PSI
122 ºF
1.5 gpm
Frequency
14,5 A
16,5 ft
24,5 ft
14 AWG x 3C with 140 °F insulation temperature
Class I
Power cord grips: Type "Y".
Washer Build Quality: Basic
Thermal insulation on motor winding: Class F
Extension Gauge
From 6 ft to 49 ft
18 AWG
16 AWG
14 AWG
8 AWG
grounded
60 Hz
Authorized Service Center.
| Higher than 49 ft
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3