Troubleshooting - Truper LAVA-2000T Manual Del Usuario

Problem Possible cause
The washer does not • The washer is not connected.
start. • Faulty power outlet.
• Blown fuse.
• Faulty extension cord.
Pressure is not • The pump is drawing air.
constant. • Valves are dirty, worn or stuck.
• Worn pump seals.
• Insufficient water supply.
The washer stops • Blown fuse.
while working. • Wrong voltage supply.
• Thermal sensor is activated.
• The nozzle is partially blocked.
The fuse blows off. • The fuse ampere capacity is low.
The washer is • There is air inside the hose.
pulsating.
• Wrong supply of the water supply.
• Nozzle is partially blocked.
• Water filter is blocked.
• Tangled hose.
The washer stops and • The pump or the high pressure gun is
starts by itself. damaged.
• There is no water inlet.
The washer starts but • The pump, hoses or accessories are frozen.
there is no water • There is no water supply.
flowing out. • The water filter is blocked.
• The nozzle is blocked.
10
ENGLISH
If despite carrying out the recommended actions the problems persist,
contact a

Troubleshooting

Solution
• Connect the washer.
• Use a different power outlet.
• Replace fuse. Shut off other machines.
• Replace the extension cord.
• Check for leaks in the hose and connections.
• Go to a
• Go to a
• Increase water pressure, double check there are no
blockages, unroll hoses completely.
• Replace fuse.
• Shut off other machines. Double check voltage
supply corresponds to the specifications in this
manual.
• Allow the washer to cool down.
• Clean the nozzle.
• Change to an installation with capacity higher
than the washer's ampere consumption.
• Try using with no extension cord.
• Press the high-pressure gun trigger until the
water flows constantly.
• Check the water supply matches the required
specifications. Avoid using long and thin hoses
(minimum ½").
• Clean the nozzle.
• Clean the filter.
• Straighten the hose.
• Go to a
Center.
• Open the water inlet.
• Wait for the pump, hoses or accessories to thaw.
• Connect the water inlet.
• Clean the filter.
• Clean the nozzle.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.
Authorized Service