Maintenance - Truper LAVA-2000T Manual Del Usuario

Maintenance

WARNING • Disconnect the power cord from the
power supply before carrying out any type of adjustment,
service or maintenance on the washer.
Cleaning and Care
• Keep the washer free of dust. Never use water or
chemical liquids to clean the washer. Clean only using a dry
and clean cloth.
• Always keep the ventilation slots clean and free of
obstructions to guarantee the proper cooling of the motor.
• Regularly inspect all the mounting screws and double
check tightness. If any of these screws is loose, tighten
immediately.
• The motor is the washer heart. Use care so that it will not
be affected by oil or water.
• Check the power cable often to detect any kind of
damage. In the event there is some damage go to a
Authorized Service Center to have it
replaced.
Connections Lubrication
• The connections in the washer hoses, the high-pressure
gun and the lance shall be cleaned regularly. To prevent
leaks and damage to the seals in each connection, lubricate
using non-water soluble grease.
Nozzle Lubrication
• The nozzles shall be regularly lubricated with non-water
soluble grease or light oil.
• A blocked nozzle increases importantly the pressure in the
pump. Clean immediately:
1) Remove the blockage in the nozzle inserting the nozzle
cleaner through the center orifice.
2) Purge the nozzle with water. Start the washer and press
the washer high-pressure gun. If the pressure is still too high
repeat steps 1 and 2.
Washer Lubrication
• Every six months, take the machine to a
Authorized Service Center to carry
out maintenance (lubricate valves and oil change).
CAUTION • In case there is an oil leak go to a
Authorized Service Center.
Water Filter
• Any foreign matter entering the washer pump may cause
damage. the washer is built with a water filter to prevent
this possibility.
• The inner screen in the washer filter shall always be kept
clean to keep a continuous flow of water into the washer
and prevent damaging the pump.
• To clean the screen, remove the filter from the garden
hose connector and unscrew to remove the screen. Handle
with care to prevent damaging the screen.
• Set back immediately both screen and connector to
prevent foreign particles entering into the pump.
Storing in Winter time
• Turn the washer OFF and press the trigger to release the
pressure trapped inside the unit.
• Remove both the garden hose and the pressure hose.
• Turn ON the washer and leave it running 5 seconds to
eliminate any water trapped inside the pump.
• Disconnect the washer and store the power cord.
• Store the washer and accessories in a dry environment
and with controlled temperature. Do not store the washer
and accessories where temperature may drop to 40 °F.
CAUTION
DAMAGES DUE TO FREEZING ARE NOT
COVERED IN THE WARRANTY.
9
ENGLISH