Mounting The Camera - D-Link DCS-8200LH Guía De Instalación Rápida

MOUNTING THE CAMERA

Please refer to the steps below to assist you with mounting the camera. It is recommended that you
configure the camera before mounting.
DCS-8200LH
Step 1:
Turn the base plate on the bottom of the camera counterclockwise
with a coin to remove it.
Step 2:
Place the base plate where you want to position the camera and
use a pencil to mark the holes. Make sure the holes are lined up
horizontally.
Step 3:
Depending on the material of the wall or ceiling, use proper tools to
drill two holes 25mm deep with a 6mm drill bit where you marked. If
the wall is made out of concrete, drill the holes first, then insert the
plastic anchors to support the screws.
Step 4:
Place the base plate over the holes that are in the wall. Make sure to
align the base plate holes with the holes in the wall. Use the supplied
screws to attach the base plate to the surface of the wall. Do not
overtighten screwheads as this may crack the mount.
Step 5:
Place the camera over the base plate and turn the camera clockwise
to lock it in place.
Step 6:
Adjust the angle of the camera as desired. When adjusting the
camera, use one hand to hold down the camera base to prevent it
from turning.
3