Setting The Timer - Ricatech RR3100 Manual Del Usuario

- The hours digit starts flashing.
3. Press the FF / o FB /
4. Press PROGRAM /
The minutes digit starts flashing
5. Hold down FF / o FB /
6. Press PROGRAM /
The minutes digit stop flashing, the clock begins to run.
7. Press PROGRAM /

Setting the timer

The unit can be used as an alarm clock, whereby the selected source (CD, TUNER, USB, SD CARD OR PHONO) to start
playback at a preset time. Make sure the clock is set before using the timer.
1. In the standby mode, press and hold TIMER /
start flashing. Press TIMER /
2. Press FF / or FB /
3. Press TIMER / on the remote to enter minutes setting mode.
4. Press FF / or FB /
on the remote again to begin ―SYSTEM POWER OFF‖ timer setting.
5. Press TIMER /
" and message ―TURN OFF‖ start flashing. Press TIMER /
Icon "
6. Press FF / or FB /
*
7. Press TIMER / on the remote to enter minutes setting mode.
8. Press FF / or FB /
9. Press TIMER / on the remote again to begin setting the source from wake up.
Default at TUNER mode. Message TUNER start flashing.
10. Press FUNCTION /
The unit will be waked up from last tuned station if TUNER mode is selected.
repeatedly to set the hours.
again to confirm.
repeatedly to set the minutes.
again to confirm.
to select between 12 and 24 hours, shown as below
again on the remote to begin the ―SYSTEM POWER ON‖ timer setting.
repeatedly to set hours.
repeatedly to set minutes.
repeatedly to set hours.
repeatedly to set minutes.
to select wake up source.
on the remote over 1 second, icon "
on the remote again to begin timer setting.
" and message‖ TURN ON‖