Installing And Removing The Battery Pack - DeWalt DCH263 Manual De Instrucciones

ENGlIsH
Fig. D
11
1
Depth Rod (Fig. E)
To Adjust the Depth Rod
1. Push in and hold the depth rod release button
the side handle.
2. Move the depth rod 13
end of the rod and the end of the bit equals the desired
drilling depth.
3. Release the button to lock rod into position. When
drilling with the depth rod, stop when end of rod
reaches surface of material.
Fig. E
13
Bit and Bit Holder

WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage bare hands.
The rotary hammer can be fitted with various chisel bits
depending on the desired application. Use sharp drill
bits only.
SDS Chuck (Fig. F)

WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage bare hands.
36
12
14 on
so the distance between the
14
To insert bit, insert shank of bit about 19 mm (3/4") into
chuck 15 . Push and rotate bit until it locks in place. The bit
will be securely held.
To release bit, pull the sleeve
Fig F
15
16
OPERATION

WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

Installing and Removing the Battery Pack

(Fig. G)
NoTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 8
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button and firmly pull the battery pack out of the tool
9
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. G
9
8
Proper Hand Position (Fig. H)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
16 back and remove the bit.
into the tool handle, align the