Measuring Resistance; Continuity Test With Buzzer - Metrix MX 350 Manual De Instrucciones

4.5. Measuring resistance

Set the switchto Ω.
Connect the red test lead to the
"+" input terminal and the black
test lead to the "COM" input
terminal.
Place the touch prods in
contact with the points to be
measured and read the result
on the display.
Note: When performing a
measurement on a circuit,
make sure that it is not live and
that the capacitors have been
discharged.

4.6. Continuity test with buzzer

Set the switch to .
Connect the red test lead to the "+" terminal and the
black test lead to the "COM" terminal.
Place the touch prods in contact with the circuit to be
tested.
If the resistance is lower than 35 Ω, the buzzer sounds
continuously.
26
Chapter II
MX 350 / MX 355