Viking DrawerMicro VMOD241SSL Guia De Instalacion página 5

Unpacking your
DrawerMicro Oven™
• Remove all packing materials from inside the
DrawerMicro Oven. DO NOT REMOVE THE
WAVEGUIDE COVER, which is located on the
top of the appliance.
Sealing Surface
Waveguide Cover
Oven Cavity
• Remove the feature sticker, if there is one. Check
the drawer for any damage, such as misaligned
or bent drawer, damaged drawer seals and
sealing surfaces, broken or loose drawer guides
and dents inside the cavity or on the front side
of the drawer. If there is any damage, do not
operate the appliance and contact your dealer
or a VIKING AUTHORIZED SERVICER.
Important Notes to the
Installer
• Read all of the Installation Manual before
installing the DrawerMicro Oven.
• Remove all packing material before connecting
the electrical supply.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the
consumer.
Important Notes to the
Consumer
Keep this manual with your Use and Care Manual
for future reference.
• As when using any microwave oven generating
heat, there are certain safety precautions you
should follow. These are listed in the Use and
Care Manual. Read all and follow carefully.
• Be sure your DrawerMicro Oven is installed and
grounded properly by a qualified installer or
service technician.
E3