Eaton LUMARK Crosstour Maxx Instrucciones De Instalación página 2

Installation Instructions - Crosstour Maxx LED Wire Guard
INSTALLATION
Tools Required
Phillips head screw driver and electrical wiring tools.
1. Install Crosstour MAXX luminaire to wall.
2. Center wire guard over the luminaire. Conduit plugs
should be centered in the open slots of the wire guard.
3. Use #8 fasteners (supplied by others) to attach wire
guard to the mounting surface. (Figure 1.)
2
EATON
IB514010EN Installation instructions
Figure 1.