12
Symptom
Possible solution
VGA picture is not stable
or synchronized
No output from one of
the speakers
Control buttons do not
work
After images appear
Appendix
To attach a wall mount bracket to your TV:
1 Remove the four M6 screws holding your TV to the
stand.
2 Secure the wall mount bracket to the back of your
TV using four M6 screws, as indicated in the
illustration.
200 mm
Attach wall bracket here
Remove M6 screws
Remove stand
• Make sure that you have
selected the correct VGA mode
on your computer.
• Adjust the balance in the Sound
menu.
• Unplug the power cord, wait a
few seconds, then plug the cord
back in and turn on your TV.
• Do not display a still image,
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent after
image to be burned into the
screen. This type of damage is
not covered by your warranty.
200 mm
200 mm
Remove M6 screws
Specifications
•
Design and specifications are subject to change
without notice.
Analog standard
NTSC
Digital standard
ATSC, 8-VSB, Clear-QAM
Screen
37-inch
Channel coverage VHF: 2-13
UHF: 14-69
CATV: Mid band - A-8 ~ A-1, A ~ I
Power source
AC 100-240 V 50/60 Hz
Power
<230 W
consumption
<1 W in standby mode
Audio power
5 W + 5 W internal speaker
S-Video input
Y:1 V(p-p), 75 ohm, negative sync
C:0.286 V(p-p) (burst signal), 75 ohm
Video/audio input
Video:1 V(p-p), 75 ohm, negative sync
Audio:150 mV(rms)
Component input
Y:1 V(p-p), 75 ohm, including sync
Pr/Cr:±0.35 V(p-p), 75 ohm
Pb/Cb:±0.35 V(p-p), 75 ohm
Audio:150 mV(rms)
Suggested resolutions:1080i, 720p,
480p, 480i
HDMI input
1 HDMI input terminal
HDCP compliant
E-EDID compliant
Suggested scan rates:1080i, 720p,
480p, 480i
VGA input
D-Sub 15-pin terminal
E-EDID compliant
Suggested scan rates:640×480 /60 Hz,
800×600 /60 Hz, 1024×768 /60 Hz,
1360x768 /60 Hz,
Audio input: Headphone mini-jack for
stereo
Accessories
Power cord
User guide
Remote control
Batteries (2 AAA)
Appendix
Super band - J ~ W
Hyper band - AA ~ ZZ, AAA, BBB
Ultra band - 65 ~ 94, 100 ~ 135