Talking And Listening - Motorola Talkabout T11 Serie Manual De Instrucciones

Adjusting the Sound (Key Beeps)
Your radio emits a beep each time one of the buttons is
pressed (except the PTT button).
Press and hold the button while turning the radio on to
switch the sound off.
To turn this sound on, turn the radio off and on again without
pressing the button.
Selecting a Channel
In order to speak to someone, both your radios must be set
to the same channel.
To select a channel:
1. Press / button until the Channel number starts to
flash.
2. Press or button to the required channel. An
extended press of or
through the channel.
3. Press PTT button to confirm the selection or
button to continue setup.

Talking and Listening

To communicate, all radios in your group must be set to the
same channel.
1. To talk, press and hold the PTT button. When
transmitting, the icon is shown.
2. When you are finished talking, release the PTT button.
10
button allows you to scroll
/
3. When receiving, the
For maximum clarity, hold the radio 1 in. away from your
mouth and speak directly into the microphone. Do not
cover the microphone while talking.
Talk Range
Your radio is designed to maximize performance and
improve transmission range. Do not use the radios closer
than 5 ft apart.
Push-to-Talk Timeout Timer
To prevent accidental transmissions and save battery life,
the radio emits a continuous warning tone and stops
transmitting if you press the PTT button for 60 s
continuously.
Channel Scan Mode
Channel Scan Mode enables your radio to scan for active
channels. When activity is detected, your radio lands (stays)
on that channel (for two seconds). To transmit on that
channel, press the PTT button. When activity on the landed
channel ends, your radio continues scanning other
channels.
To turn the channel scan on:
1. Press / button two times until
2. Press / button to start scanning. Press
button or PTT button to turn off Scan mode.
icon is shown.
icon appears.
/