Troubleshooting - Kalorik USK STP 20159 Manual De Instrucciones

Prensa de planchar
Ocultar thumbs Ver también para USK STP 20159:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fax +32 2 359 95 50
TROUBLE SHOOTING
PROBLEM
Steam press cannot be
opened with the
handle
Steam press becomes
warm but DOES NOT
remove wrinkles.
Press DOES NOT get
warm.
No Steam
Water drips from the
pressing plate.
The handle will not
move into the
automatic maximum
pressure position.
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
CAUSE
Locking knob is in
locked position
Temperature setting is
not high enough for the
fabric attempted.
Temperature has not
been selected
Press is not plugged
into an outlet.
Automatic Shut-Off has
engaged. The pressing
plate has been raised
for more than 15
minutes without use.
Water Level is too low.
Controls have not been
properly set.
Burst of steam button
has been pressed too
long.
Item on the ironing
board is too thick to use
this pressure.
10
Assembly page 10/24
special
instruction
from
Team
Print only
SOLUTION
Turn the locking knob
to the unlocked
position
Gradually increase the
temperature until
obtaining the desired
results.
Make a proper
selection.
Plug the appliance in.
Press "ON/OFF" again.
Fill the water tank.
If suitable for the fabric,
make a selection to a
higher temperature.
Wait for the steam
ready light to come on.
If not use spray misting
bottle as directed.
Don t press the burst of
steam button more
than 5 seconds
continuously.
Use lighter pressure on
thicker items. Use
added steam for
wrinkles.
USK STP 20159 - 110127

Publicidad

Tabla de contenido
loading

Tabla de contenido