Installing The Led Assembly And Glass Shade - Hinkley TREY 52 Manual De Instrucciones

INSTALLING THE LED ASSEMBLY AND GLASS SHADE

WARNING: Before starting installation, disconnect the power by turning off
the circuit breaker or removing the fuse at fuse box. Turning power off
using the fan switch is not sufficient to prevent electric shock.
Remove the 1 of 3 screws from the posts of the light kit decora
tive housing and keep it for future use. Loosen the other 2
screws. (Do not remove)
While holding the LED assembly under your fan, make the polarize
2
plug connections: (Fig. 2)
- Red to white
- Black to black
Place the key holes on the LED assembly over the 2 screws
3
previously loosened, turn the LED assembly until it locks in place at
the narrow section of the key holes. Secure by tightening the 2
screws previously loosened and the one previously removed. (Fig. 1)
Raise glass shade up against mounting plate and secure it to the
4
fan by turning the glass shade clockwise until snug. DO NOT
OVERTIGHTEN.
5
Restore power and your light kit is ready for operation.
10 | hinkley.com
Wire Connectors
Mounting Plate
LED
Assembly
Fig. 1
Mounting Plate
Glass
Shade
Fig. 2
Screws