MTD 19A30003OEM Manual Del Operador página 9

Assemble Mounting Brackets
To assemble the bagger mounting assembly, locate the hitch
bracket kit and follow these steps:
1. Attach the right-hand and left hand rider hitch bracket
to the universal rear attachment bracket using the four
carriage bolts (710-0276) and flange lock nuts (712-04063)
packed with the mounting brackets. Position the brackets
with the hooks on the right-hand and left hand rider hitch
bracket pointing downward, and the tabs on the universal
rear attachment bracket pointing upwards. See Fig. 4-3.
Note: This universal mounting bracket assembly is
designed to work with other available attachments, such
as a weight kit used in conjunction with the snow blade or
snow thrower attachment. Utilize the contact information
on page 2, or contact the retailer in which you purchased
this equipment, to find out more about available
attachments for your specific tractor.
Figure 4-3
2. Flip over assembly and mount the hitch support bracket
to the mounting assembly using four 710-3008 hex bolts
and 712-04063 flange lock nuts from hardware pack
689-00087. See Fig. 4-4 for proper orientation of the
bracket.
Note: When attaching the hitch support, it is best to not
fully tighten the bracket at this time. This will facilitate the
mounting process in later steps, which will then require
fully tightening this hitch support bracket.
Assembling The Bag Support Assembly
Locate the upright support bracket and the bag support
assembly. Assemble it by following these steps:
1. Lay the bag support assembly topside down with the
mounting bracket portion facing upwards.
2. Insert the notched end of the vertical support bracket into
the bag support assembly, as in Fig. 4-5, and secure with
a carriage bolt (710-0276) and flange lock nut (712-04063)
from hardware pack 689-00080. See Fig. 4-6.
For 700 Model Series
Universal
Rear Bracket
Hitch Side
Bracket
Side View
Side View
Figure 4-4
Figure 4-5
Figure 4-6
s 4 — a
ectiOn
All Other Models
& i
sseMbly nstallatiOn
9