English; Important; Care Instructions - IKEA TRADFRI Manual Del Usuario

ENGLISH

HOW TO STEER YOUR LIGHTING
The switch on your power supply cord will
make it possible to turn ON/OFF all products
connected to the TRÅDFRI driver, but if you
want to dim or connect your products to IKEA
Smart lighting products, you need to buy a
separate TRÅDFRI steering device (e.g. a
remote control).
The TRÅDFRI steering device needs to be
paired with your TRÅDFRI driver/s. If you have
more than one (1) driver you can pair each
one with the steering device, so that the entire
combination can be turned ON/OFF or dimmed
at the same time.
Depending on how easy it will be to access the
driver please consider to pair the TRÅDFRI
driver/s with your steering device before the
final placement of the driver/s and cords.
PAIRING A STEERING DEVICE
TO YOUR DRIVER
1. Connect at least one (1) product to the
driver before you begin the pairing.
Make sure that the power supply cord is
connected to a power socket and that the
switch on the cord set is turned ON.
2. Locate the pairing symbol
Hold the steering device close to the pairing
symbol (no more than 5 cm away).
3. Press and hold the pairing button
steering device for at least 10 seconds. A
red light will shine steadily on the steering
device.
The product connected to the driver will
begin to dim and flash one time to indicate
that the driver is being paired to the
steering device.
HOW TO FACTORY RESET YOUR DRIVER
If the driver does not respond or if you want to
un-pair the driver from a steering device you
might have to make a factory reset. The driver
is forced to factory reset by carefully inserting
a paper clip end or similar in the small hole
(marked RESET) in the driver enclosure and
applying a slight pressure.

IMPORTANT!

— The driver is for indoor use only and can
— Do not leave the driver in direct sunlight or
— Do not subject the driver to wet, moist or
— The declared radio range between the

CARE INSTRUCTIONS

To clean the driver, wipe with a dry soft cloth.
Never use abrasive cleaners or chemical
solvents as this can damage the product.
PRODUCT SERVICING
Do not attempt to repair this product yourself,
as opening or removing covers may expose
you to dangerous voltage points or other risks.
TECHNICAL DATA
Type:
Input voltage: 220-240Vac, 50-60Hz
on the driver.
Output voltage: 24Vdc
Max output power: 30W
For indoor use only
on the
Radio range: 10 m in open air.
Operating frequency: 2405-2480Mhz
Output power: 14 dBm
The crossed-out wheeled bin symbol indicates
that the item should be disposed of separately
from household waste. The item should be
handed in for recycling in accordance with
local environmental regulations for waste
disposal. By separating a marked item from
household waste, you will help reduce the
volume of waste sent to incinerators or land-
fill and minimize any potential negative impact
on human health and the environment. For
more information, please contact your IKEA
store.
be used in temperatures ranging from 5ºC
to 45 ºC.
near any heat source, as it may overheat.
excessively dusty environments as this
may cause damage.
driver and the steering device is measured
in open air. Different building materials
and placement of the units can affect the
wireless connectivity range.
30 W
ICPSHC24-30EU-IL-1
4