Overload Protector - Kenmore 116.22812 Manual Del Propietário

FABRIC BRUSH
FLOOR BRUSH
(Some Models)
Power.Mate ®
Handi-Mate Jr.=
(Some Models)*"
PowePMate Jr,®
(Some Models)*'*
Furniture*
x
x
x
x
x
x
x x X
X** X
X
X
'Always clean attachments before using on fabrics "* 3-way OnlOff switch should be in FLOOR position
"** Handi-Mate Jr" and Power-Mate Jr.2 altachment instructions are included with the products
NOTE: When separating wands, depress Iock, bu!ton completely before Rullinc_ wands apart. If
wand lock button is d ff cut to eepress, pusn the two wanes more [ignuy _ogetner to line up
the lock button with the hole. Depress lock button and then pu wan_s aparL
Active brush edge
cleaners are on both
sides of the Power-
Mate ®. Guide either
side of the Power-Mate _
along base-boards or
next to furniture to
help remove dirt
trapped at carpet
edges.
OVERLOAD PROTECTOR
The Power-Mate ®has
built-in
protection
Overload Protector
against motor and belt
Reset Button
damage should the
agitator jam. if the
agitator slows down or
stops, the overload
protector shuts off the
PoNer-Mate®_ T h e
canister motor will continue to run_
To correct problem: Turn off vacuum,
remove obstruction, then press reset button.
To reset: Push in the overload protector
button°
The suction
control allows
you to change
the vacuum
suction for
different fabric suction suction
and carpet
weights. Opening the control decreases
suction for draperies and lightweight rugs,
while closing the control increases suction
for upholsteries and carpets.
12
i i iil,,llr '1
WARNING
Personal Injury Hazard
Always unplug the vacuum cleaner
before cleaning the agitator area as
brush may suddenly restart, Failure
to do so can result in personal
injury,