Exhaust Filter Changing - Kenmore 116.22812 Manual Del Propietário

_ i =, ,i , unllu
WARNING
Fire andtor Electrical Shock Hazard
Do not operate with a clogged
exhaust filter or without the exhaust
filter or exhaust filter cover installed.
i
EXHAUST FILTER
HEPA
The exhaust fitter cartridge must be
replaced when dirty, Replace the filter when
the entire surface area is covered evenly°
The filter CANNOT be washed as it will
lose its dust trapping ability,
NOTE: See PARTS AND FEATURES for
Exhaust Filter Number
1. Pull up on Exhaust _ t
the exhaust ill- Filter AM/.* I
ter cover
tO
Cover_....._..._._;_/,._ ./
remove from _
the motor cover
and lay aside°
2. Slightly push
the exhaust filter
cartridge to the
side, as shown in
the illustration,
and pull up to
remove.
3. Replace the
exhaust filter car-
tridge, carefully Exhaust
positioning it so
that the side
shown in the
illustration goes
down under the
ribs. Then push
the other side
down until it snaps into place° Place the new
filter into the motor cover with the grey
edge down.
Exhaust
4. Replace the
exhaust filter
cover by engag-
ing the two tabs
on the rear and
pushing down in
front until it
snaps closed.
Always follow all safety precautions when
cleaning and servicing the Power-Mate ®.
. WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting°
16