Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical
Shock Hazard
Unplug power cord from electrical
outlet.
Do not operate the cleaner
without the primary or exhaust filters.
Be sure the filters
are properly
installed to prevent motor failure
and/or electrical
shock.
PRIMARY FILTER
Check primary filter frequently
and clean
when dirty.
TO REMOVE
PRIMARY
FILTER
Remove the dust bin and dust bin lid
assembly as outlined in the DUST BIN
CLEANING
section.
While holding
primary filter
over a trash con-
tainer grasp fil-
ter, rotate and lift
off.
Cleaning
Cam
Slot
Filter
Locking
Tab
Filter Cover
Clean primary filter by gently tapping over a
trash container. Tap on several sides to
ensure best cleaning. Rinse with water
only as needed,
do not use any detergent
or soap. Allow the filter to dry for 24 hours
before
putting
it back into the vacuum.
When cleaning
the filter no longer restores
vacuum suction to full power you need to
replace the filter.
Note:
See PARTS AND FEATURES
for the filter number.
TO REPLACE
PRIMARY
FILTER
With slot side on
Cleaning
Cam
filter towards the
Slot
filter cover slide
Filter
cleaning cam
inside opening,
rotate filter clock-
wise
until slots
Locking Tab
lock onto tabs in
Filter Cover
cover.
Note: Under normal use and care, your fil-
ter can be expected
to last up to 5 years.
Re-assemble
dust bin lid to dust bin. Insert
into cleaner and secure with dust bin latch.
17
EXHAUST FILTER
HEPA
The exhaust filter must be replaced when
dirty.
It should be replaced
regularly
depending
on use conditions.
The filter CANNOT be washed as it will
lose its dust trapping ability.
Note:
See PARTS AND FEATURES
for the filter number.
Remove filter cover by pulling out at the
top of the exhaust filter cover.
Exhaust_
Filter
Exhaust
Filter Cover
,,'_
Pull_
Here
_
Bottom
Tabs
Remove
the
exhaust
fil-
ter car-
tridge.
Push only on filter cartridge frame, not on
filter material itself.
Grey
Exhaust
Filter Seal
The foam seal of the filter should be
placed against the vacuum
cleaner body
Replace the exhaust
filter cover by placing
bottom tabs in slots and pushing
in until
cover snaps into place.
Publicidad
Tabla de contenido
