Honeywell PRO 4000 Serie Informacion De Producto

Programmable
Digital
Thermostat
Product
Information
Thermostat controls
Fan Switch is used to control
your fan.
Auto: Fan runs only when
heating or cooling system is on.
On: Fan runs continuously.
Display screen
Low battery Temperature setting
(or Desired Temperature
warning
when changing temperature)
Current inside
temperature
Replace Batt
Inside
75
Current program
Recovery
period
6 : 30
Wake/Leave/
Return/Sleep
Wake
Wed
Adaptive Intelligent
Recovery
TM
Current day/time
Built-in compressor protection
Damage can occur if the
compressor is restarted too
soon after shutdown. This
feature forces the compressor
to wait for a few minutes before
restarting.
During the wait time, the display
will flash the message Cool On
(or Heat On if you have a heat
pump). When the safe wait time
has elapsed, the message stops
flashing and the compressor
turns on.
CAUTION
Equipment damage hazard
To prevent possible compressor damage, do not operate
cooling system when outdoor temperature is below 50°F
(10°C).
Press to set desired temperature.
Note: Set SYSTEM switch to the
system you want to control (Heat or
Cool).
Set: Sets time/day/schedule.
Hold: Overrides programmed
temperature.
Run: Resumes program schedule.
System switch is used to control
your heating or cooling system.
Cool: Cooling system control.
Off: All systems off.
Heat: Heating system control.
Em Heat: Emergency & Auxiliary
Heat control. Compressor is locked
out. (Select models only.)
System Status
Cool On: Cooling system is on.
Heat On: Heating system is on.
Em: Emergency heat is on.
Set T o
75
Aux: Auxiliary heat is on.
AM ** Only for heat pumps with this
Em Aux capability (select models only).
Heat On
If flashing, compressor
protection is engaged.
Inside
75
6 : 30
AM
Wake
Wed
Message flashes until safe restart
time has elapsed.
PRO
4000
For more details on how to program your thermostat,
information about Adaptive Intelligent Recovery, and how to
replace batteries:
Product Manuals
Search online for Honeywell 69-1760EFS for the Installation
Guide.
Search online for Honeywell 69-1928EFS for the User Guide.
Quick Reference
Grasp and pull to see basic operating
instructions at a glance.
To adjust program schedules
NOTE: Make sure the
thermostat is set to the system
you want to program (Heat or
**
Cool).
**
1. Press SET until Set Schedule
is displayed.
2. Press or
s
weekday Wake time (Mon-
Fri), then press SET.
3. Press or
s
temperature for this time
period, then press SET.
4. Repeat steps 2 and 3 for
each weekday time period.
5. Press SET to set weekend
time periods (Sat-Sun), then
Set T o
press RUN to save & exit.
75
Cool
On
MCR29477
Series
to set your
t
to set the
t
Set T o
75
Set Schedule
6 : 30
AM
Heat
Wake
MonTueWedThuFri
Set T o
75
Set Schedule
6 : 30
AM
Heat
Wake
MonTueWedThuFri
33-00301EFS-01