Maintenance; Customer Responsibilities - Craftsman 919.167810 El Manual Del Propietario

Ocultar thumbs Ver también para 919.167810:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CUSTOMER RESPONSIBILITIES

Check Safety Valve
Drain Tank
Oil Leaks
Check Pump Oil
Change Pump Oil
Unusual Noise and/or
Vibration
Air Filter
Drive Belt-Condition
Motor Pulley/Flywheel
alignment
Air compressor pump
intake and exhaust
valves
Inspect air lines and
fittings for leaks
Head Bolts - Check the torques of the head bolts after the first five hours of operation.
1- more frequent in dusty or humid conditions
cycles automatically when power
is on. When servicing, you may
be exposed to voltage sources,
compressed air, or moving parts.
Before servicing unit unplug or
disconnect electrical supply to
the air compressor, bleed tank
of pressure, and allow the air
compressor to cool.
To ensure efficient operation and lon-
ger life of the air compressor, a routine
maintenance schedule should be pre-
pared and followed. The above routine
maintenance schedule is geared to an
air compressor in a normal working
environment operating on a daily basis.
If necessary, the schedule should be
modified to suit the conditions under
which your air compressor is used.
The modifications will depend upon
the hours of operation and the work-
ing environment. Compressors in an
extremely dirty and/or hostile environ-
ment will require a greater frequency of
all maintenance checks.
N000395

MAINTENANCE

Before
Daily
each
or
use
after
each
use
*
Risk of Unsafe
Operation. Unit
Every
Every
8
40
hours
hours
NOTE: See Operation section for the
location of controls.
TO CHECK SAFETY VALVE
does not work properly, over-
pressurization may occur, causing
air tank rupture or an explosion.
wear certified safety equipment:
ANSI Z87.1 eye protection (CAN/
CSA Z94.3) with side shields.
1.
Before starting compressor, pull
the ring on the safety valve to
make sure that the safety valve
operates freely. If the valve
is stuck or does not operate
smoothly, it must be replaced
with the same type of valve.
16-ENG
Every
Every
100
160
hours
hours
Risk of Bursting.
If the safety valve
Risk from Flying
Objects. Always
Yearly

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido