Kenmore 721.24195 Manual Del Propietário página 12

4. Carefully insert and lift screwdriver at each
brush support to free brush from base.
Base
5. Remove worn belt.
6. Slide brush supports off to check and
clean brush support areas. See PARTS
LIST for picture of complete brush
assembly.
TO REPLACE BELT:
1. Install brush supports onto brush.
Brush support
Brush
2. Install new belt in belt groove on the
brush, then over the fan shaft. Be sure belt
is between the belt guards. Refer to parts
list for replacement belt number.
Belt
Guard
Belt Groove
3. Insert each support into its base slot.
4. Push cover and base together.
-12-