Automatic Mode Operation - Weston PRO-1100 Manual De Instrucciones

AUTOMATIC MODE OPERATION

BEFORE ATTEMPTING VACUUM
FIGURE 9
PACKAGING BE SURE THAT THE
Vacuum Port
VACUUM SEALER IS SET UP IN
ACCORDANCE WITH ALL OF THE
SAFETY PRECAUTIONS LISTED IN
THIS BOOKLET.
1. Place the items to be vacuum
sealed into a vacuum bag. Allow at
least 2" (5 cm) at the open end of
the bag in order to create enough
seal space. Be sure not to cover the
Vacuum Port (FIGURE 9).
2. Close the Vacuum Lid while holding
the bag in place. Press down on both
Leave 2"
Seal
sides of the lid to lock the lid in place.
Space
You will hear each side "click" when it is
secured. NOTE: If both sides are NOT
securely locked, the lid will NOT release
automatically. To resolve this issue, press down on both sides of the lid twice to
release the locks.
3. Press and release the Start Button. The 2-Piston Vacuum Pump will begin
removing air from the bag while the LED Vacuum Window begins to count up.
You may need to apply light pressure to the Vacuum Lid during the count-
up process. The LED Vacuum Window will count up starting at the number
"1" and going thru to the number "9", before automatically engaging the bag
sealing process. These numbers represent stages, not seconds.
4. Once the LED Vacuum Window displays the number "9", the sealing
process will begin by counting down from your chosen setting to "0" on the
LED Seal Window.
5. Once the LED Seal Window has reached "0", the Vacuum Sealer will
automatically stop the 2-Piston Vacuum Pump and release the vacuum
pressure moments later. DO NOT ATTEMPT TO PULL THE VACUUM LID
OPEN BEFORE THE VACUUM HAS BEEN RELEASED, SEVERE DAMAGE
TO THE SEALING BAR WILL RESULT.
12