Eaton LUMARK WPMLED Instrucciones De Instalación página 2

Installation Instructions - WPMLED
INSTALLATION
Tools Required
Philips screwdriver, Torx T-20 bit (included), 6mm multi-bit
screw driver or 6mm socket, 1/4" drill bit.
1. Open the fixture by loosening the two tamper resistant
screws wit Torx T-20 bit included on the side opposite
the hinges and remove the glass door assembly.
Remove drain plugs.
2. Prepare the back plate for mounting by drilling or
knocking out the appropriate holes. (Figure 2.)
3. Line up the back plate in the desired location and
mount securely.
4. If using electrical conduit, remove the screw cap from
the desired conduit hole and replace with conduit.
Route the branch circuit wires inside the fixture. If
using a junction box, bring the branch circuit wires
through the rear hole into the fixture.
5. Splice the branch circuit power leads to the fixture
power leads, black to black (hot), white to white
(neutral), and green to green (ground).
6. Reattach the LED module and driver module to the
back plate.
7 . Replace the lens assembly using the provided
tamper-proof screws.
N ote: Mounting height to be a minimum of 6 feet.
Mounting
The back plate has a cast-in drill and knock-out template
to match any standard recessed junction box, three 5/16"
knock-outs for mounting holes A and three 1/2" NPS tapped
holes D for surface conduit or photocontrol unit.
A – 5/16" diameter Knockouts.
B – 9/16" diameter Knockouts.
C – Knockouts for #10 screw.
D – 1/2" NPS tapped holes.
Important
To weather-proof your outdoor installation, use silicone
sealant to seal all holes in the fixture housing (mounting,
conduit, plugs, photocontrols, etc.) and all edges between
the fixture housing and the mounting surface.
2
EATON
IB514013EN Installation instructions
Figure 1.
A
D
B
A
Figure 2.
D
A
C
D
C