Longshine LCS-8131N Manual Del Usario página 25

WPS AP List
Rescan
Information
PIN Code
Config Mode
Table of Credentials Display all of credentials got from the Registrar. List
Detail
Connect
Rotate
Disconnect
Delete
PIN
PBC
WPS associate IE
WPS probe IE
Progress Bar
Status Bar
Note: When you click PIN or PBC, please don't do any rescan within two-minute
connection. If you want to abort this setup within the interval, restart PIN/PBC or
press Disconnect to stop WPS action.
Display the information of surrounding APs with WPS IE
from last scan result. List information includes SSID, BSSID,
Channel, ID (Device Password ID), and Security-Enabled.
Click to rescan the wireless networks.
Display the information about WPS IE on the selected
network. List information include Authentication Type,
Encryption Type, Config Methods, Device Password ID,
Selected Registrar, State, Version, AP Setup Locked, UUID-E
and RF Bands.
8-digit numbers. It is required to enter PIN Code into
Registrar using PIN method. Each Network card has only
one PIN Code of Enrollee.
Enrollee or an external Registrar.
information includes SSID, MAC Address, Authentication
and Encryption Type. If STA Enrollee, credentials are
created as soon as each WPS success. If STA Registrar,
Utility creates
WPA2-PSK/AES/64Hex-Key and doesn't change until next
switching to STA Registrar.
Information about Security and Key in the credential.
Command to connect to the selected network inside
credentials.
Command connect to the next network inside credentials
Stop WPS action and disconnect this active link. And then
select the last profile at the Profile Page of Utility if exist. If
there is an empty profile page, the driver will select any
non-secure AP.
Delete an existing credential. And then select the next
credential if exist. If there is an empty credential, the driver
will select any non-security AP.
Start to add to Registrar using PIN configuration method.
Start to add to AP using PBC configuration method.
Send the association request with WPS IE during WPS
setup. It is optional for STA.
Send the probe request with WPS IE during WPS setup. It is
optional for STA.
Display rate of progress from Start to Connected status.
Display currently WPS Status.
24
a new credential with