Axkid Modukid Infant Manual De Instrucciones página 11

Adjusting the baby car seat to fit your child
Check the belt position in relation to the child. The belt position should be just above the
1
child´s shoulders. Check this regularly as your child grows. If needed, adjust the belt position
according to steps 2-7.
Create slack on the belt by using the harness adjustment button (M) and pulling the shoulder
2
Belt (P) at the same time.
Open the harness by pushing the belt buckle button (N) and separating the two connectors.
3
Open the shoulder pads (O) and pull out the belt with connectors and the shoulder pad strap
4
through the belt openings (V).
If needed, add the baby insert and cushion (J, K). We recommend using the insert and cushions
5
if your child is approximately between 0-3 months to ensure an appropriate fit.
Now you can put the shoulder belts and shoulder pad strap in a different opening (V) that better
6
suits your child' s height. To reach the highest belt position, flip open the ASIP bar cover (G).
Close the shoulder pads (O) around belts and attach the connectors into the belt buckle (N).
Make sure that the belts are not twisted.
7
IMPORTANT: Make sure that the belts are not twisted.
Buckle your child in the seat
Put the baby car seat on a flat surface. Hold down the belt adjustment button (M) and at the
same time pull the shoulder section of the harness (P) until it is fully pulled out. Fold away the
8 harness (P) so that they will be easy to reach after you have placed your child in the baby car
seat. Place your child in the baby car seat. Make sure there are no blankets or thick clothing
between the child and the back of the baby car seat.
9
Place the shoulder belts over your child' s shoulders, as close to the neck as possible.
Lock the harness (P) by pushing the two connectors together and then insert them into the
10
belt buckle (N).
11 Pull the belt adjustment strap (L) to tighten the harness (P).
12
There should be approximately 1 cm of space between the child' s shoulders and the belt.
5