Axkid Modukid Infant Manual De Instrucciones página 12

IMPORTANT:
When tightening the harness, it is important that you have the baby car seat on a flat surface. The
child' s position could be very different if the baby car seat is angled which may cause the harness to be
insufficiently tightened.
Make sure that the belt is not twisted in any way.
Do not use any other belt routing than described in this manual.
Allowed and disallowed positioning of the
baby car seat
The Axkid Modukid Infant can be used on any forward-facing passenger seat which has a three-
point seat belt (i) approved to UN/ECE regulation number 16 or other equivalent standard, as long as
there is no active airbag in place. The baby car seat cannot be used with a two-point lap belt (ii).
The Axkid Modukid Infant can also be used together with the Axkid Modukid Base on any forward-
facing passenger seat which has ISOFIX connection points.
IMPORTANT: If you wish to install your Axkid Modukid Infant in a location where an airbag is fitted,
then the airbag must be disconnected at an authorized service center. Some vehicles may be
equipped with a switch which allows you to manually switch the airbag off. It is important to always
check if the vehicle' s indicator light shows that the airbag is turned off.
WARNING: Never use on a seat with an active airbag
WARNING: Never use on rearward or side facing vehicle seats
WARNING: Air bags are designed for adults and can seriously harm your child in a crash
13
Allowed and disallowed positioning of the child car seat.
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Forward facing seat with 3-point seat belt
Seat with 2-point seat belt
Side facing seats
Rear facing seats
14
This baby car seat is only allowed to be mounted rear-facing.
Never install a child restraint in a passenger seat
where an active airbag is fitted.
6
Yes
NO
Yes
NO
NO
NO