Axkid Modukid Infant Manual De Instrucciones página 13

Installation in the car
Base installation
For installation together with base see instruction manual for Axkid Modukid Base.
Belt installation
15 Make sure that there is space between the baby car seat and the interior of the car.
16
Start by placing the baby car seat in the correct vehicle seat position, according to (13).
17
Adjust the handle of the baby car seat to position P1.
Pull out sufficient length of vehicle seat belt (T, U) around the baby car seat and buckle the belt
18
(S).
19 Guide the vehicle' s lap belt (T) through the hooks (N) on the baby car seat.
Pull the vehicle' s shoulder belt (U) around the seat and fix it in the hooks on the rear side (J) of
20
the baby car seat.
Push down the baby car seat in the vehicle' s seat and then pull the belt as tight as you can to
21
make sure that the baby car seat gets the most fixed position possible.
Axkid has equipped the Axkid Modukid Infant with a side impact protection system, ASIP
22
(Axkid Side Impact Protection). Pull the ASIP (H) towards the door of the car until it locks in its
outer position.
IMPORTANT: Do not use any other vehicle seat belt routing then described in this manual. If so you
are facing a risk of the baby car seat not being properly fastened which can lead to serious injuries.
7