GE AKL08 Manual Del Propietario E Instrucciones De Instalación página 15

8
Assemble the Supports
Loosely attach a support bracket to a support
A
rail using 2 Type C screws.
Type C screws
NOTE: The support bracket may be attached into
either slot in the support rail, depending on the depth
of your window sill.
Thread a nut onto a leveling bolt, then
B
thread the leveling bolt into the support
bracket. An adjustable wrench may be needed.
9
Install the Supports
Line up the V-notches in the support rails with
A
the left and right marks on the stool. Make
sure that the support rail is against the back
of the stool and drill two 1/8" pilot holes into
the stool through the holes in the head of the
support rail. Attach the supports to the stool
using two Type B screws in each support.
Type B
screws
Support rail
Support bracket
Support bracket
Nut
Leveling bolt
Sill
Supports
Stool
Before attaching the support, hold the neck of
C
the support rail against the back edge of the
window stool.
Stool
Neck of
support rail
Adjust the position of the support bracket
D
inward or outward on the support rail until the
leveling bolt is near the outside edge of the sill.
NOTE: Make sure that the leveling bolt will be firmly
supported by the sill.
Tighten the Type C screws to secure the
E
support bracket to the support rail in the
correct position.
Repeat steps A–E to assemble the second
F
support.
Adjust the leveling bolts against the sill so that
B
the supports have a slight tilt to the outside.
Use a level; about 1/2 bubble will be the
correct slant to the outside. After leveling is
done, tighten the leveling bolt nut.
NOTE: Use a steel washer between the leveling
bolts and the sill if the sill is weak.
Attach the adhesive side of the window stool seal
C
(thick, adhesive-backed) to the window stool.
Window stool seal
Adjust as
needed
1/2 bubble
Nut
Leveling bolt
15