Bosch HGS7052UC Manual Del Usuario página 8

Adjust Broil Burner Air Shutter
More Open:
•Less Yellow Flame
More Closed:
•Less Blue Flame
•More Carryover
•Less lifting or blowing
Figure 8
The air shutter is located on the back end of the broil
burner. It is attached to the top of the oven cavity with
7 screws. Remove screws and gently pull broil burner
assembly straight out being careful not to detach
electrical wires. Place broil burner against back wall of
oven cavity. Loosen screw and turn shutter. Close the
shutter if the flame is lifting or blowing or not carrying
over; Open the shutter if it is too yellow (see Figure
8). Tighten screw. Replace broil assembly being
careful to feed all wires through the back of the oven.
Reinsert all 7 screws.
Note: The air shutter on the broil burner fits over the
orifice when installed correctly.
Replacement Parts: Visit your Bosch dealer for replacement parts. For a dealer near you contact Bosch
Service at 800-944-2904.
English • 6
Step 6: Final Steps - Adjust the Flame (if necessary)
Allow Burner(s) to cool before
attempting to remove them!
(if necessary)
Shutter
Screw
WARNING:
Adjust Bake Burner Air Shutter
Shutter
More Open:
•Less Yellow Flame
Figure 9
The oven burner air shutter is located near the oven
regulator. Reach it through the access hole in the
interior back panel of the warming drawer (loosen
screws and remove access panel). Loosen screw on
shutter. Close the shutter if the flame is lifting or
blowing or not carrying over; Open the shutter if it is
too yellow. Tighten screw. Reattach cover plate and
replace warming drawer (see Figure 9).
(if necessary)
More Closed:
•Less Blue Flame
•More Carryover
•Less lifting or blowing