Storing And Transporting The Appliance; Cleaning And Maintenance - Rowenta INTENSIUM RO6629 Manual Del Usuario

(fig.6)
surfaces... .
3 • Storing and transporting
the appliance
After use, stop your vacuum cleaner by
pressing the On / Off pedal and unplug it
(fig.7)
. Rewind the power cord by pressing
the cord winder pedal

CLEANING AND MAINTENANCE

The air we breathe contains particles that may be
allergens: mite larvae and droppings, mould,
pollen, smoke and animal residues (hair, skin,
saliva, urine). The smallest particles penetrate
deep into the respiratory system where they can
cause inflammation and cause lung impairment.
HEPA filters (High Efficiency Particulate Air) are
used to filter out the smallest particles.
With the HEPA filter, the air released back into the
room is healthier than the air that is vacuumed.
IMPORTANT
your vacuum cleaner before maintenance
or cleaning. Regularly check and clean all of
your vacuum cleaner and the various filters.
ATTENTION
vacuum cleaner without the filtration
system (foam, microfilter and filter).
1 • Empty the dust
compartment (5)
Empty the dust box after each use as follows:
Take the dust compartment by the handle
(fig.11)
and pull it
Press the dust compartment opening button
(fig.12)
and then empty it
Clean the edges of the dust compartment
(fig.14)
with a cloth
Put the dust compartment back in place
(fig.15)
.
ATTENTION
maximum level given on the dust
compartment.
(fig.8)
.
Always stop and unplug
Never operate
.
(fig.13)
.
.
Never exceed
Carry your vacuum cleaner easily thanks to
its carry handle (10). Do not carry your
vacuum cleaner by the dust compartment
(fig.9)
handle
When you store your vacuum cleaner, place
the tube in his housing at the rear of your
(fig.10)
appliance
2 • Clean the dust
compartment joints
Remove the dust compartment
Clean the dust compartment joints with a
(fig.14)
cloth
Replace the dust compartment
3 • Clean the black foam filter (19)
IMPORTANT
the suction is no longer satisfactory,
wash the black foam filter.
Press the lid opening button
lid back cover
Remove the black foam filter
wash and wring it
the
for at least 12 hours before putting it back.
ATTENTION
filter to dry and make sure it is thoroughly
dry before putting it back in the appliance.
Replace the black foam filter and close the lid.
4 • Clean the microfilter (20)
IMPORTANT
the microfilter.
Press the button to open the lid
the lid back
Remove the black foam filter
the
then remove the microfilter
Wash the microfilter
for at least 12 hours before putting it back.
9
.
.
.
(fig.15)
Every 6 months or when
(fig.16)
(fig.17)
.
(fig.18)
(fig.19)
. Leave it to dry
Leave the black foam
Every 3 months, wash
(fig.16)
(fig.17)
.
(fig.18)
(fig.20)
(fig.21)
. Leave it to dry
EN
(fig.11)
.
.
. Tilt the
then
. Tilt
and
.