Cleaning; Cleaning After Daily Use; Cleaning After Installation Of A New Beertender Keg; Routine Cleaning - Krups BeerTender VB32 Manual Del Usuario

English

CLEANING

In addition to routine cleaning, the BeerTender should be cleaned after daily
■
use and when you install a new BeerTender Keg.
WARNING!
microwave and/or conventional oven.

CLEANING AFTER DAILY USE

The drip tray and grate should be cleaned after every use. Remove the grate
■
before emptying out the drip tray. The grate must be set back in place during
normal use of the BeerTender - fig. 23.
Note: You can wash the drip tray with warm water and a mild detergent. The
drip tray is also dishwasher safe.
WARNING!
solvents or petrol.
CLEANING AFTER INSTALLATION
OF A NEW BEERTENDER KEG
When you install a new BeerTender Keg you must clean the dispensing
■
spout. The spout is the only part of the appliance that comes into contact
with the beer - fig. 24.
It is essential to wash the spout either normally by hand or in a dishwasher.
Note: the dispensing spout comprises plastic and metal parts that are
permanently joined together and do not pose any problems of hygiene. Do not
attempt to separate these parts.
The beer dispensing mechanism must be cleaned using a damp cloth and
■
a mild detergent - fig. 25.
Note: use a piece of cotton to thoroughly clean all the parts - fig. 26.
WARNING!
sharp objects: it is a precision component and you will risk damaging it.

ROUTINE CLEANING

Clean the appliance cooling chamber on a regular basis using a damp cloth
■
and mild detergent - fig. 27.
WARNING!
permanent damage. Never use aggressive agents such as vinegar, acids,
solvents or petrol.
The tap cover can be removed. Clean it with warm water and a mild
■
detergent.
28
Do not dry the appliance and/or its components in a
Never use aggressive cleaning agents such as vinegar, acids,
Do not attempt to clean the mechanism using hard and/or
Do not fill the cooling chamber with water as this may result in