Connecting To The Power Supply; Using The Beertender; Inserting A Beertender Keg - Krups BeerTender VB32 Manual Del Usuario

The drip tray must be positioned on a level surface and must
WARNING!
not jut out from the surface it is resting on.
After installing the BeerTender appliance you must clean the dispensing
■
spout; this is the only part of the appliance that will come into contact with
the beer - fig. 8.
It is essential that you wash the dispensing spout before using the appliance
■
for the first time and at least every time a new keg is connected inside the
BeerTender system. This part can also be washed in a dishwasher - fig. 9.
To clean the spout, remove it from its housing by turning it clockwise. After
■
washing the spout, screw it back into place.

CONNECTING TO THE POWER SUPPLY

Electricity can be dangerous! Therefore you must always scrupulously
abide by the safety rules.
The appliance must be plugged into a suitable, properly installed electric
■
socket.
The voltage of the appliance has been set in the factory. Check that the
■
mains voltage matches the voltage indicated on the rating plate on the rear
of the appliance.
Make sure the main switch on the rear of the machine is set to "0" before
■
connecting the BeerTender to the mains. Insert the plug into a socket with
the correct voltage and turn on the appliance by moving the main switch to
"I" - fig. 10.
The appliance will immediately start cooling the inner chamber as soon as the
main switch is set to "I".
USING THE BEERTENDER SYSTEM

INSERTING A BEERTENDER KEG

Note: the BeerTender may only be used with BeerTender Kegs "Compatible
■
BeerTender" containing beer sold by the Heineken group.
The appliance can only be used if it contains a BeerTender Keg and only if
■
the main switch is set to "I".
The LED on the left side of the control panel, when illuminated, tells you that
■
the appliance is switched on.
You can open the appliance by pressing the handle on top of the lid. When
■
the handle is released, you can lift the lid up - fig. 11-12.
Note: do not force the lid beyond the set opening position as this could
damage it.
When the lid is completely open, insert a BeerTender Keg as shown in the
■
figure - fig. 13.
English
25