Rola 59310 Guía De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
59307 1-1/4 in. / 59308 2 in. Base Units
CENTER SUPPORT ASSEMBLY
Assembly is shown using vehicle receiver. If vehicle is not available,
assembly can be done on ground or table.
1. Slide single bike center support (A or B) into vehicle receiver. Secure
12mm anti-rattle hitch pin bolt (J) with either 19mm wrench (M) or 8mm
allen wrench (N). Install supplied hitch pin clip (I) or hitch pin bolt lock
(R) to end of hitch pin bolt (J). FIG 1.
2. Loosen (8) screws with 4mm allen wrench (O), but do not remove.
FIG 2.
3. Connect front wheel tube (D) to single bike center support (A or B) by
aligning tube slots with center support tabs.
Then, slide front wheel tube (D) into single bike center support (B) until
it is seated against the internal stop (approximately 4"). FIG 3.
4. Slide rear wheel cradle with strap (F) onto rear cradle tube (E) with
buckle side facing rearward. FIG 4.
5. Connect rear cradle tube (E) to single bike center support (A or B) by
aligning tube slots with center support tabs, then slide rear cradle tube
(D) into single bike center support (A or B) until it is seated against the
internal stop (approximately 4"). FIG 5.
6. Tighten (8) screws with 4mm allen wrench (O). FIG 2.
5
Center support tabs
Tube slots
E
Rear cradle tube
PAGE 4
1
L
K
J
2
3
Center support tabs
B
Tube slots
Single
bike center
support
4
Buckle side
rearward
E
Rear
cradle tube
Buckle
59307_59308_59310_IN_Rev A • Questions? (800) 234-6992 • RolaProducts.com
B
Base unit-Single bike
center support
J
R
I
J
D
Front
wheel
tube
F
Rear cradle
with strap
Tube slots