Dmx Linking - Chauvet Professional Q-WASH 560Z-LED Guía De Referencia Rápida

EN
AC Power
AC Plug
Replacing
the Fuse

DMX Linking

DMX Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the safety cap and replace with a fuse of
the exact same type and rating (F5 220V).
5. Insert the fuse holder back in place and reconnect power.
The Q-Wash™ 560Z-LED will work with a DMX controller using a regular
DMX serial connection.
www.chauvetpro.com.
The Q-Wash™ 560Z-LED uses a regular DMX data connection for its
DMX personalities: Basic, Advanced, and G1. See the User Manual to
connect and configure for DMX operation.
The Q-Wash™ 560Z-LED uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
Q-Wash™ 560Z-LED QRG
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
A DMX
3
Screw Color
Brown Yellow/Brass
Blue
Green
Primer is available
Silver
from