ResMed AirFit N30 Guia Del Usuario página 5

Disassembling your mask for cleaning
1. Firmly pinch one side of the cushion and pull away from the frame.
2. Unhook the headgear from the stabilizer by pulling on the end cap to
reveal the buttonhole.
3. Slide the headgear off the end of the stabilizer.
Cleaning your mask
After each use: Cushion
Weekly: Headgear and frame
1. Soak the components in warm water with a mild liquid detergent.
2. Hand wash the components with a soft bristle brush. Pay particular
attention to the vent.
3. Thoroughly rinse the components under running water.
4. Shake the frame to remove any excess water from the vent. Leave
the components to air dry out of direct sunlight.
If the mask components are not visibly clean, repeat the cleaning steps.
Make sure that the vent is clean and clear.
4