Stanley FATMAX PP1DCS Manual De Instruccion página 9

OVERVIEW
Common Actions and Unit Responses
The following actions turn the unit on and activate the LCD screen:
Press the Battery Status Button.
(Refer to the "Viewing Battery Status"
section.)
Press the Alternator Check Button.
(Refer to the "Alternator Check"
section.)
Press the LED Area Light Power Button.
(Refer to the "LED Area Light" section.)
Press the USB Power Button. (Refer to
the "USB Ports" section.)
Press the Compressor Power Button.
(Refer to the "Portable Compressor"
section.)
Whenever the clamps are properly
connected to a battery (refer to the
"Jump Starter" section) ...
If the Jump Starter Power Switch is
rotated to the on position and the
clamps are not connected to a battery
(refer to the "Jump Starter" section) ...
If the clamp connections to the
battery's positive and negative
terminals are reversed (refer to the
"Jump Starter" section) ...
When the unit is charging or
recharging using the built-in 120 Volt
AC Charger (refer to the "Charging/
Recharging" section) ...
Note:
The unit will automatically power off once ALL the functions are turned off.
VIEWING BATTERY STATUS
To check the unit's battery charge level, press the Battery Status Button. The Battery Status Icon and Battery Voltage Indicator
will display for 10 seconds (only), indicating the battery charge level as follows.
• If the battery charge level is at full capacity, four solid bars will display.
• If the battery is partially charged, two or three solid bars will display.
A beep will sound and the backlit LCD screen will display the Battery Status
Icon and Battery Voltage Indicator for 10 seconds before the unit automatically
turns off.
A beep will sound and the backlit LCD screen will display the Battery Status
Icon, and the Alternator Icon will flash. The unit remains on until the Alternator
Check Button is pressed again to turn it off.
A beep will sound and the Area Light will turn on. The backlight will turn on for
10 seconds (only). The LCD screen will continue to display the Battery Status
Icon and Battery Voltage Indicator. The unit remains on until the LED Area Light
Power Button is pressed again to turn it off.
A beep will sound and the backlit LCD screen will display the Battery Status
Icon and Battery Voltage Indicator, as well as the USB Icon, indicating the 4 USB
Ports are available. The unit remains on until the USB Power Button is pressed
again to turn it off.
A beep will sound and the backlit LCD screen will display the Battery Status
Icon, "XXX" PSI and the Compressor Icon. If no further actions are taken after
1 minute, the unit will display the Battery Status Icon and Battery Voltage
Indicator for 10 seconds before automatically turning off.
... a beep will sound and the backlit LCD screen will display the Battery Status
Icon, Battery Voltage Indicator, the Clamp Icons, and the "+" and"–" signs, as
well as the flashing Jump Starter Icon. The unit remains on until the clamps are
disconnected from the battery.
... a two-second warning will sound every 10 seconds. The backlit LCD screen will
display the Battery Status Icon, Battery Voltage Indicator, the Clamp Icons, and
the "+" and "–" signs. The Alarm Icon and the Jump Starter Icon will flash. The
unit remains on until the Jump Starter Power Switch is switched off and then
displays the battery status icon and the voltage of digital display for 10 seconds
before automatic shut down.
... the backlit LCD screen will display the Battery Status Icon, Battery Voltage
Indicator, and the Clamp Icons. The Alarm Icon, the "+" and "–" signs and the
Arrow Icons will flash and the unit will sound a warning continuously until the
clamps are disconnected from the battery.
... a beep will sound and the backlight will turn on for 10 seconds (only). The
LCD screen will continue to display the Battery Status Icon and Battery Voltage
Indicator. The bars on the Battery Status Icon will change from empty to solid
(bottom to top) repeatedly.
8