Shindaiwa POWERBROOM PB3410 Manual Del Propietário página 7

Assembly (continued)
Sweeper Assembly (sold separately)
1. Push one of the drum axles onto either
of the two gearcase output shafts. If
necessary, rotate the drum axle until
the clevis pin hole in the axle aligns
with the matching hole in the gearcase
output shaft.
CAUTION!
The two drum assemblies are identi-
cal, but each drum must be installed
with its recessed end facing toward
the gearcase.
Drum
Assembly
2. Use a clevis pin and hitch pin to secure
the drum axle to the shaft.
3. Slide the recessed end of a sweeper
drum assembly over the installed axle,
and then push the drum down the axle
until the cotter pin hole in the axle
extends above the drum surface.
4. Use a cotter pin to secure the drum
assembly on the axle (see inset). The
cotter pin is designed to fit tightly
against the outboard end of the drum,
so you may need to compress the drum
face slightly during installation. spead
the ends of the cotter pin to secure.
2
Secure the drum
axle to the shaft
Clevis
Pin
Drum
Axle
Cotter
Pin
Secure with a
cotter pin
4
Install the sweeper drum
assembly
Hitch
Pin
Install drum
1
axle onto
output shaft
3
5. Repeat Steps 1-4 to install the remain-
ing axle and drum assembly.
The PowerBroom tool should now
be completely assembled.
7