Spare Parts; Troubleshooting - Oase PondoVac 5 Instrucciones De Uso

- English -
Storage/Winterization
● When not in use, unit must be stored.
○ Drain the unit as far as possible, clean thoroughly and check for damage.
○ Empty all hoses, pipes and connections as far as possible.
○ Store the unit in a dry and frost-free place, inaccessible to children.

Spare parts

The use of original parts from OASE ensures continued safe and reliable operation of the unit. Please visit our website for
spare parts drawings and spare parts
Disposal
Do not dispose of this unit with domestic waste! Disable the unit beforehand by cutting off the cables. Further
information about the recycling of this product can be obtained from your local municipal authority.

Troubleshooting

Issue Cause
The unit does not No mains voltage
switch on
Pump housing, discharge hose or non-return valve clogged.
Defective pump
Plug connector of the pump cable open
Moisture in the plug connector of the pump cable
Discharge hose is too high up.
The unit cannot The water level in the tank is too high.
be switched on, a • The float in the vacuum head has closed the intake for
warning signal has longer than 15 s.
sounded. • The float in the vacuum head has closed the intake three
times within 60 s.
Water vapor is In cold weather condensate forms in the unit, which is
escaping from the released in the form of water vapour
unit.
No suction or No mains voltage
reduction in
Excessive height difference between water level and unit
suction
Debris collection bag is full
Dirt clogging the foam filter, suction tube or suction hose
Non-return valve jammed or soiled
Low suction Slide on the suction handle is open
capacity
Increased tube friction resistance
Excessive suction depth Due to the design the
suction capacity reduces from a suction depth of 2 m.
The tank is not • Discharge hose kinked
emptying, the • The discharge hose is too high (max. 6.6 ft. higher than
vacuum head the unit).
keeps switching • The discharge hose is too long (65 ft.).
off.
Discharge hose or non-return valve clogged
with dirt
The discharge pump is clogged.
Solution
Switch on mains voltage
Remove dirt
Replace the pump.
Close the plug connector.
Open the plug connector and allow it to dry.
Route the discharge hose in a lower position
(max. 6.6 ft.above the base of the unit)
Clean the tank.
• Ensure that the float can move freely.
To reset the malfunction: Switch off the unit
and then switch it on again
This is normal. No remedy necessary
Check the mains voltage
Set up the vacuum cleaner on ground that is
not much higher than the water level
Empty the debris collection bag.
Remove dirt.
Clean
Close the slide on the suction handle
Keep the suction hose as short and flat as
possible.
Reduce the suction depth
Route the discharge hose correctly.
• Remove dirt from the discharge hose.
• Clean the non-return valve.
• Clean the discharge pump.
• Clean the non-return valve
12