Installation And Connection - Oase PondoVac 5 Instrucciones De Uso

- English -
Fitting the inlet
Prerequisite: The tank is open
1. Insert the intake distributor into the opening.
○ Guide the pins on the intake distributor
through the notches of the opening
2. Twist the intake distributor to lock it into place
(bayonet closure).
○ Ensure that the outlet of the intake distributor in the
tank is angled downwards.
3. Fit the debris collection bag onto the intake distributor in the tank.
○ Ensure that the elastic of the debris collection bag is seated in the groove
of the intake distributor.
○ Secure the debris collection bag with the Velcro tape.

Installation and connection

Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries due to operation of electrical units or installations in or
near ponds/pools.
Protective measures:
• Set up the unit at least 6.6 ft. away from the pond/pool.
• Ensure that the ground under the unit is firm and horizontal so that the unit cannot tip over
Note!
The vacuum cleaner can be set up and operated in a position that is up to 1 ft. lower than the water level
Possible consequences: When the vacuum cleaner is switched off, the water will automatically flow through the
tank while the suction hose remains in the pond/pool. The pond/pool will be emptied.
Remedy: Always take the suction hose out of the pool/pond when the vacuum cleaner is switched off
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
6
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
7