Max/Min; Automatic Power Off; Maintenance; Cleaning And Storage - koban KPA-1000 Manual Del Usuario

KPA-1000
2. To exit this mode, press and Hold the REL button until "
Press and hold the Flashlight button to turn the Flashlight on. Press and hold the button
again to turn the Flashlight off.
3. With rotary switch on Voltage and Current positions, select AC Voltage an AC Current
mode. the Hz% key permits to select the frequency test ( Hz ) or the duty cycle test(%).

6.10.5 MAX/MIN

Press MAX/IN key the maximum and minimum values are measured. This mode is
activated on each measurement except for continuity test, diode test capacitance test,
frequency test and duty cycle test.
This mode is disabled keeping pressed MAX/MIN key or moving the rotary switch.

6.10.6 Automatic Power OFF

In order to conserve battery life, the meter will automatically turn off after approximately
15 minutes. To turn the meter on again, turn the function switch to the OFF position and
then to the desired function position.

7. Maintenance

WARNING: To avoid electrical shock, disconnect the meter from any circuit, remove
the test leads from the input terminals, and turn OFF the meter before opening the
case. Do not operate the meter with an open case.

7.1 Cleaning and Storage

Periodically wipe the case with a damp cloth and mild detergent; do not use abrasives or
solvents. If the meter is not to be used for 60 days or more, remove the battery and store
it separately.

7.2Battery Replacement

1. Remove the Phillips head screw that secures the rear battery door
2. Open the battery compartment
3. Replace the 3*1.5V AA battery
4. Secure the battery compartment

7.3 Temperature Probe Replacement

The replacement bead wire probe (with banana plug connectors) is CATIV1000V
Note: To use a Type K thermocouple probe that is terminated by a subminiature (flat
blade) connector, a subminiature-to-banana plug adaptor (Part Number TP879) is required.
13
EN
" is no longer in the display.
EN KPA-1000
14