Preparing The Bodypack Transmitter For Use; Inserting And Replacing The Batteries; Inserting And Charging The Accupack - Sennheiser ew 500 G2 Serie Instrucciones Para El Uso

Preparing the bodypack
transmitter for use

Inserting and replacing the batteries

For powering the transmitter, two 1.5 V AA size batteries
are required.
Press the two unlocking buttons
battery compartment cover
Insert the two batteries as shown above. Please observe
correct polarity when inserting the batteries.
Close the
compartment cover
click.

Inserting and charging the accupack

The transmitter can also be powered via the rechargeable
Sennheiser BA 2015 accupack. Insert the accupack into the
battery compartment as described above.
The transmitter has two charging contacts
contact on its short sides. The accupack can be recharged
while remaining in the transmitter. Insert the transmitter
into the L 2015 charger (see operating manual of the
L 2015 charger).
Note:
For accupack operation of the transmitter, only use the
BA 2015 accupack in order to ensure optimum
operational reliability. For charging the accupack, only
use the L 2015 charger. Both the accupack and the
charger are available as accessories.
The accupack is fitted with an integrated sensor which is
– via a third contact – monitored by the electronics of
the transmitter and the charger. The sensor is necessary
for the following control purposes:
10
battery compartment.
locks into place with an audible
and open the
.
The
and a sensing
battery