Adjusting The Sensitivity - Sennheiser ew 500 G2 Serie Instrucciones Para El Uso

Use the
transmission frequency. Transmission frequencies are
tunable in 25-kHz steps within a switching bandwidth
of 36 MHz max. For intermodulation-free frequencies,
please refer to the enclosed frequency table.
Adjusting the sensitivity –
Via the "SENSIT" menu, you can adjust the transmitter's
input sensitivity.
The input sensitivity is adjusted too high when close talking
distances, speakers with loud voices or loud music passages
cause overmodulation in the transmission link. In this case,
the transmitter's yellow LED (AF PEAK)
If, on the other hand, the sensitivity is adjusted too low, the
transmission link will be undermodulated, which would
result in a signal with high background noise.
The sensitivity is correctly adjusted when the level display
for audio signal "AF"
the loudest passages.
Note:
For monitoring
transmitter's level display for audio signal "AF" always
indicates the audio level – even if the transmitter is
muted.
The following figures are a guide to the best settings:
Loud music/vocals:
Presentations:
Interviews:
Musical instruments:
electric guitars with
single coil pickups:
electric guitars with
humbucker pickups:
guitars with active
electronics (active pickups,
active EQs, piezo pickups):
/ rocker button to select the desired
shows full deflection only during
the
–30 to –20 dB
–20 to –10 dB
–10 to 0 dB
SENSIT
will light up.
adjusted sensitivity,
–20 to –10 dB
–30 to –20 dB
the
–10 bis 0 dB
21