Chicco Tre Jogging Manual Del Propietário página 19

Tabla de contenido

Publicidad

To Attach Bumper Bar
Installation du Barra de protección
WARNING
Bumper Bar is required to be
attached when using it along with
KeyFit® car seat. Do not use as a
travel system without the Bumper
Bar properly attached.
27
36
ADVERTENCIA
La barra de protección debe estar
sujetada cuando se utiliza el
cochecito con el asiento de
seguridad KeyFit. No lo utilice
como sistema de viaje sin la barra de
protección correctamente sujetada.
27. Attach the Bumper Bar to the Arm
Rest on the Stroller Frame. Tilt the
Bumper Bar as shown.
27. Sujete la barra de protección
al apoyabrazos en la estructura del
cochecito. Incline la barra de
protección como se muestra.
To Attach Bumper Bar
Installation du Barra de protección
28
Plastic
A.
Tab
B.
C.
D.
KeyFit®
"CLICK!"
Attachment
"CLIC"
28. When installing Bumper Bar, place
the Plastic Tabs in between the Arm
Rest and Seat Fabric (A). Slide the
Bumper Bar rearward along the top
edges of the Arm Rests (B). Make
sure the Seat Fabric is between
the Plastic Tab and the KeyFit®
attachment. The KeyFit® attachment
must be on the outside of the Seat
Fabric in the occupant area. When
the Bumper Bar's Plastic Tab stops
and catches on the Arm Rest groove
(C). Push down on the front edge of
the Bumper Bar to lock it into place
with a click (D), engaging the metal
hooks.
Note: The KeyFit® Infant Carrier will
only lock into place when the Bumper
Bar is attached correctly. The KeyFit®
attachment needs to be outside the
Seat Fabric.
37

Publicidad

Tabla de contenido
loading

Tabla de contenido